Constant Power Wire – must receive 8-30 volts regardless of engine state.4-pin connector – provides power to GPSĭo not plug these cables into the GPS unit at this time.10-pin connector – provides engine data to GPS.Secure all excess cable lengths, cable runs, and unused cable connections/cable ends so that they cannot move or become loose over the lifetime of the installation.
#2017 CASCADEA ANTENNA INSTALLATION INSTALL#
GPS & Cable Overview Zonar Installation Kitĭo not install Zonar devices or any excess cabling inside fuse panels, fuse boxes, or in any other location where the device or cabling (particularly unused cable ends/connections) might come into contact with energized circuits. See Failed Inspections for guidance on correcting these. If a trailer is not created in the system but is used when doing inspections, this can cause inspections to fail. A GPS ID is not required for trailers unless one has been installed. Required: Add the trailer to Ground Traffic Control (GTC) like other assets but with the TRAILER asset type. These tags include both a 9-digit asset number and a zone number 01-03. They ship in sets of two (2) or three (3) tags with the name “Ext. Trailer/Dolly Tags are considered “Extended Asset” tags and may be black or marigold colored.
Perform an electronic inspection to ensure correct tag placement.Depending on the configuration, not all zone tags may be used. Install the zone tags in the proper areas for the corresponding vehicle inspection type.See the Zonar Configuration Document for proper zone tag placement.
#2017 CASCADEA ANTENNA INSTALLATION HOW TO#
The following is an example of how to record this information on an Asset sheet:
0 kommentar(er)
